A working diary, not a publication. Short entries while a build is in motion — date, what happened, what I learned. Filter by project to follow one thread.
Smaller screws, pins the printer could not print, a label, a clamp for the cable, and a jig that flashes a board on the first try.
Designing a 3D-printed jig with spring pins to flash the buttons, and the simple question that changed the whole design: what stops the pins from falling through?
A new way to make a button forget its address, a button that said it had forgotten but kept answering anyway, and a test sketch that was fooling me too.
A small ESP32 library so that using the buttons feels like "button 5, go amber" rather than register addresses and bytes.
Every button keeps its own time, and given a few minutes they all drift apart. One message that every button hears at once fixed it.
Thirty identical buttons on one bus, and none of them knows its address. The trick that solved it, and the empty memory that turned out not to be empty.
The first real firmware: colours, blinking and a smooth pulse, and why a light at 50% power does not look half as bright.
Designing an 18 mm board, ordering it assembled, and the rare pleasure of a first revision that needed no fixes at all.
I wanted the glowing square buttons from aircraft cockpits for my sim and my workshop. They were too big, too expensive and too dumb, so I started from a blank board.
Staring at a result and thinking "that does not look safe" turned out to be a better instinct than the maths sitting behind it.